Learn with Anil · TGPSC HMWSSB Manager (Engineering) PYQsPractise online →Subscribe ₹149

TGPSC HMWSSB Manager Analog Circuits previous year questions with answers

Every Analog Circuits question asked in the TGPSC HMWSSB Manager (Engineering) papers on this site, grouped by topic. Answers come from TSPSC's final key; each has a short explanation (free here for a sample, all of them in the practice app).

Practise Analog Circuits online

Transistor Amplifiers & Biasing

  1. Manager 2015 Paper 2 (ECE) · Q10 · Analog Circuits · Transistor Amplifiers & Biasing

    In a transistor h_fe =50, h_ie=830Ω, h_oe=10⁻⁴ mho. Its output resistance when used in CB configuration is about

    1. 2 MΩ
    2. 2.5 MΩ
    3. 500Ω
    4. 500 KΩ
    Show answer

    Answer: (4) 500 KΩ

    The common-base output admittance is h_ob = h_oe/(1 + h_fe) = 10⁻⁴/51 ≈ 1.96 × 10⁻⁶ mho. So the CB output resistance is 1/h_ob = 51/10⁻⁴ = 510 kΩ, i.e. about 500 kΩ, much higher than the CE value 1/h_oe = 10 kΩ.

  2. Manager 2015 Paper 2 (ECE) · Q26 · Analog Circuits · Transistor Amplifiers & Biasing

    The self bias is used in amplifiers to

    1. reduce the cost of the circuit
    2. reduce the dc base current
    3. make the operating point almost independent of β
    4. limit the input ac signal going to the base terminal
    Show answer

    Answer: (3) make the operating point almost independent of β

    Explanation: open it in the practice app. It needs the ₹149 All-in-One Pass: one payment for every exam on the site.

  3. Manager 2015 Paper 2 (ECE) · Q27 · Analog Circuits · Transistor Amplifiers & Biasing

    The h- parameter equivalent circuit of a BJT is valid for

    1. low frequency, large signal operation
    2. low frequency, small signal operation
    3. high frequency, small signal operation
    4. high frequency, large signal operation
    Show answer

    Answer: (2) low frequency, small signal operation

    Explanation: open it in the practice app. It needs the ₹149 All-in-One Pass: one payment for every exam on the site.

  4. Manager 2015 Paper 2 (ECE) · Q30 · Analog Circuits · Transistor Amplifiers & Biasing

    The gain of a transistor amplifier falls at high frequency due to the

    1. coupling capacitor at the output
    2. skin effect
    3. internal capacitances of device
    4. coupling capacitor at the input
    Show answer

    Answer: (3) internal capacitances of device

    Explanation: open it in the practice app. It needs the ₹149 All-in-One Pass: one payment for every exam on the site.

  5. Manager 2015 Paper 2 (ECE) · Q31 · Analog Circuits · Transistor Amplifiers & Biasing

    Darlington pair consists of the following two stages

    1. both CE
    2. CE and CB
    3. CE and CC
    4. both CC
    Show answer

    Answer: (4) both CC

    Explanation: open it in the practice app. It needs the ₹149 All-in-One Pass: one payment for every exam on the site.

  6. Manager 2015 Paper 2 (ECE) · Q33 · Analog Circuits · Transistor Amplifiers & Biasing

    The main function of the transformer used in the output of a power amplifier is

    1. to step up the voltage
    2. to step down the voltage
    3. to match the load impedance with dynamic output resistance of the transistor
    4. to increase voltage gain
    Show answer

    Answer: (3) to match the load impedance with dynamic output resistance of the transistor

    Explanation: open it in the practice app. It needs the ₹149 All-in-One Pass: one payment for every exam on the site.

  7. Manager 2015 Paper 2 (ECE) · Q34 · Analog Circuits · Transistor Amplifiers & Biasing

    The bandwidth of a double tuned transformer coupled amplifier can be adjusted by varying the

    1. coupling coefficient
    2. value of the inductance
    3. value of the emitter biasing resistance
    4. value of resistance
    Show answer

    Answer: (1) coupling coefficient

    Explanation: open it in the practice app. It needs the ₹149 All-in-One Pass: one payment for every exam on the site.

  8. Manager 2015 Paper 2 (ECE) · Q35 · Analog Circuits · Transistor Amplifiers & Biasing

    Crossover distortion results in

    1. class B output stage
    2. common emitter output stage
    3. class AB output stage
    4. class A output stage
    Show answer

    Answer: (1) class B output stage

    Explanation: open it in the practice app. It needs the ₹149 All-in-One Pass: one payment for every exam on the site.

  9. Manager 2015 Paper 2 (ECE) · Q46 · Analog Circuits · Transistor Amplifiers & Biasing

    Typical value of h_ie is

    1. 1KΩ
    2. 1 Ω
    3. 100 KΩ
    4. 50 Ω
    Show answer

    Answer: (1) 1KΩ

    Explanation: open it in the practice app. It needs the ₹149 All-in-One Pass: one payment for every exam on the site.

  10. Manager 2015 Paper 2 (ECE) · Q50 · Analog Circuits · Transistor Amplifiers & Biasing

    Maximum theoretical conversion efficiency of class B amplifier is

    1. 7.85%
    2. 25%
    3. 50%
    4. 78.5%
    Show answer

    Answer: (4) 78.5%

    Explanation: open it in the practice app. It needs the ₹149 All-in-One Pass: one payment for every exam on the site.

Op-Amps & Linear ICs

  1. Manager 2015 Paper 2 (ECE) · Q11 · Analog Circuits · Op-Amps & Linear ICs

    The circuit shown in the figure can be used as a

    Figure for question 11
    1. full wave rectifier
    2. voltage to frequency converter
    3. logarithmic amplifier
    4. frequency to voltage converter
    Show answer

    Answer: (3) logarithmic amplifier

    Explanation: open it in the practice app. It needs the ₹149 All-in-One Pass: one payment for every exam on the site.

  2. Manager 2015 Paper 2 (ECE) · Q48 · Analog Circuits · Op-Amps & Linear ICs

    The ideal Op-Amp has following characteristics

    1. R_i = ∞, A = ∞, R_0 = 0
    2. R_i = 0, A = ∞, R_0 = 0
    3. R_i = ∞, A = ∞, R_0 = ∞
    4. R_i = 0, A = ∞, R_0 = ∞
    Show answer

    Answer: (1) R_i = ∞, A = ∞, R_0 = 0

    Explanation: open it in the practice app. It needs the ₹149 All-in-One Pass: one payment for every exam on the site.

Feedback, Oscillators & Power Supplies

  1. Manager 2015 Paper 2 (ECE) · Q28 · Analog Circuits · Feedback, Oscillators & Power Supplies

    In a centre-tap full wave rectifier, V_m is the peak voltage between the centre-tap and one of the secondary. The maximum voltage across the reverse biased diode is

    1. V_m
    2. 2 V_m
    3. V_m/2
    4. 3 V_m
    Show answer

    Answer: (2) 2 V_m

    Explanation: open it in the practice app. It needs the ₹149 All-in-One Pass: one payment for every exam on the site.

  2. Manager 2015 Paper 2 (ECE) · Q32 · Analog Circuits · Feedback, Oscillators & Power Supplies

    The voltage gain of an amplifier is 100. On applying negative feedback with β = 0.03, its gain will reduce to

    1. 50
    2. 2.5
    3. 3.0
    4. 25
    Show answer

    Answer: (4) 25

    Explanation: open it in the practice app. It needs the ₹149 All-in-One Pass: one payment for every exam on the site.

  3. Manager 2015 Paper 2 (ECE) · Q36 · Analog Circuits · Feedback, Oscillators & Power Supplies

    In transistor series voltage regulator the transistor behaves like a variable

    1. resistor
    2. capacitor
    3. inductor
    4. resistor and capacitor
    Show answer

    Answer: (1) resistor

    Explanation: open it in the practice app. It needs the ₹149 All-in-One Pass: one payment for every exam on the site.

  4. Manager 2015 Paper 2 (ECE) · Q49 · Analog Circuits · Feedback, Oscillators & Power Supplies

    In a half-wave rectifier, if an a.c supply is 60Hz, then the a.c ripple at output will be

    1. 6Hz
    2. 30Hz
    3. 60Hz
    4. 120Hz
    Show answer

    Answer: (3) 60Hz

    Explanation: open it in the practice app. It needs the ₹149 All-in-One Pass: one payment for every exam on the site.